BUILT FOR RECESSED INSTALLATION: Measuring approximately 36"W x 6.3"D x 20"H, the unit is designed to sit inside a prepared wall opening. Confirm the finished opening and wall support against the physical fireplace before installation.
SEPARATE LIGHTING CONTROLS: Adjust the flame display and crystal ember-bed lighting independently through seven settings each, including single-color, blended, and cycling effects for different room styles and occasions.
OPTIONAL SUPPLEMENTAL WARMTH: The 1400W heater provides thermostat selections from 62°F to 82°F. Because the flame and heater functions are controlled separately, the visual display may also be used when additional heat is not needed.
REMOTE OR TOP-PANEL OPERATION: Control power, heat, temperature, flame lighting, ember-bed lighting, and timer settings from the included remote or the control panel located along the top-right side of the fireplace.
TIMER FOR DAILY ROUTINES: Select a 30-minute setting or choose operating intervals from 1 to 6 hours. The black linear frame and crystal media suit media walls, living rooms, bedrooms, offices, and entertainment areas.
ASIN: B0H3P2L3V5
All orders are processed within 1-2 business days if the stock is available.
If we are out of stock on certain items, shipments may be delayed by a few days. In this case, we will contact you via email or telephone.
We have a 30-day return policy, which means you have 30 days after receiving your item to request a return label to Amazon.
All our products purchased from Amazon and MegaWise official store are covered by a 1-year warranty, starting from the date of purchase.
Frequently ask questions
Our 1500A is suitable for petrol engines up to 7L and diesel engines up to 5L. While the 2500 A is suitable for petrol engines up to 8L and diesel engines up to 8L.
1. Turn on your jump starter and ensure it has a charge of over 50%. (Charge fully before initial use). 2. Insert jumper cables into the jumping port. The digital display will light up. 3.Connet the red clamp to the positive(+) terminal and the black clamp to the negative(-) terminal of the car battery. 4. Start your engine.
To determine if the unit is charging, you can check the indicator lights. The 4 indicator lights should be flashing.
1. Plug the cable of your cell phone or tablet into one of the two USB charging ports. 2. Press the power button.
Press and hold the power button for 2 sec to turn on the LED flashlight, and short-press to switch modes(high/SOS/strobe). Press and hold for 2 seconds again to turn it off.
There are 4 red LED lights, if all are lit the unit is charged.