36-INCH BUILT-IN FORMAT: Measures approximately 36"W x 6.3"D x 20"H for a clean recessed profile. Verify the finished wall opening against the actual unit dimensions before installation.
1400W SUPPLEMENTAL HEAT: Adjustable thermostat settings from 62°F to 82°F help tailor indoor comfort. Use the heater when needed or operate the flame effect without heat for year-round ambiance.
7 FLAME MODES AND 7 EMBER COLORS: Choose warm, cool, mixed, or cycling light effects around the included crystal bed to coordinate the fireplace appearance with different rooms and occasions.
REMOTE AND PANEL CONTROL: Adjust power, heat, flame, ember bed, temperature, and timer from the built-in control panel or included remote, with an operating range of up to approximately 13 ft.
30-MINUTE TO 6-HOUR TIMER: Set the operating time from 30 minutes to 6 hours. The black recessed frame is suitable for living rooms, bedrooms, apartments, offices, and entertainment walls.
B0FY67SGPL
All orders are processed within 1-2 business days if the stock is available.
If we are out of stock on certain items, shipments may be delayed by a few days. In this case, we will contact you via email or telephone.
We have a 30-day return policy, which means you have 30 days after receiving your item to request a return label to Amazon.
All our products purchased from Amazon and MegaWise official store are covered by a 1-year warranty, starting from the date of purchase.
Frequently ask questions
Our 1500A is suitable for petrol engines up to 7L and diesel engines up to 5L. While the 2500 A is suitable for petrol engines up to 8L and diesel engines up to 8L.
1. Turn on your jump starter and ensure it has a charge of over 50%. (Charge fully before initial use). 2. Insert jumper cables into the jumping port. The digital display will light up. 3.Connet the red clamp to the positive(+) terminal and the black clamp to the negative(-) terminal of the car battery. 4. Start your engine.
To determine if the unit is charging, you can check the indicator lights. The 4 indicator lights should be flashing.
1. Plug the cable of your cell phone or tablet into one of the two USB charging ports. 2. Press the power button.
Press and hold the power button for 2 sec to turn on the LED flashlight, and short-press to switch modes(high/SOS/strobe). Press and hold for 2 seconds again to turn it off.
There are 4 red LED lights, if all are lit the unit is charged.